Paper
26 March 2019 Characterization of STEM alignments and their automation
Author Affiliations +
Abstract
Each of six scanning transmission electron microscope (STEM) system alignments were characterized with a sensitivity test to better understand the impact of the alignment on microscope automation for acquisition and metrology. The upper and lower limits of the alignment sensitivity combined with the accuracy of the automated system alignments are used to determine the process capability index (Cpk). The primary limiting factor for the alignment sensitivity was passing the metrology dynamic precision criteria of <0.3nm. Strong alignment offset showed impact on the autofunction robustness, but was marginal in comparison to the metrology sensitivity. All six of the STEM system alignments resulted in Cpk values greater than 1.3, supporting a three sigma quality process. Based on these results, criteria can be defined for alignment offset limits that will trigger automated preventative maintenance (APM) re-alignments and ensure that automated STEM metrology will meet the accuracy and precision requirements for adequate process control.
© (2019) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ashley Tilson and Silvia Aerts "Characterization of STEM alignments and their automation", Proc. SPIE 10959, Metrology, Inspection, and Process Control for Microlithography XXXIII, 109592V (26 March 2019); https://doi.org/10.1117/12.2514837
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Metrology

Optical alignment

Diffraction

Scanning transmission electron microscopy

Microscopes

Monochromatic aberrations

Visualization

RELATED CONTENT

An evaluation of edge roll off on 28nm FDSOI (fully...
Proceedings of SPIE (March 24 2016)
Confocal microscopy in transmitted light
Proceedings of SPIE (October 09 2003)
System Considerations For A Large Astronomical Space Telescope
Proceedings of SPIE (September 01 1972)
Strehi Ratio For Square Segments Of A Parabolic Mirror.
Proceedings of SPIE (January 29 1989)
Advances in process overlay on 300-mm wafers
Proceedings of SPIE (July 16 2002)

Back to Top