Paper
14 November 1997 Visible sensor for yield stress caused by cyclic loading
Kensuke Ichinose, Kiyoshi Taniuchi, Yoshimi Kosaka, Kenji Gomi
Author Affiliations +
Proceedings Volume 3241, Smart Materials, Structures, and Integrated Systems; (1997) https://doi.org/10.1117/12.293519
Event: Far East and Pacific Rim Symposium on Smart Materials, Structures, and MEMS, 1997, Adelaide, Australia
Abstract
Yield point is one of the most important mechanical properties of materials, however, there have not been any rules for obtaining the yield point caused by cyclic loading. Also in the case of analyzing the fatigue phenomena, the mechanical properties obtained by tension testing are normally used. It is widely known that when a tensile load is applied to a plane carbon steel specimen, Lueders' lines corresponding to yield stress occur on the surface. We decided to utilize Lueders' lines, in order to obtain the yield point under cyclic loading, therefore we investigated the state of their surface. Then it was clarified that we can utilize Lueders' lines in order to detect the yield point caused by cyclic loading. And that is used to detect the failure place of structural members. This method is very easy, namely only to have a smooth finish at the fixed portion, we can observe an occurrence of the striped pattern by the naked eye.
© (1997) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kensuke Ichinose, Kiyoshi Taniuchi, Yoshimi Kosaka, and Kenji Gomi "Visible sensor for yield stress caused by cyclic loading", Proc. SPIE 3241, Smart Materials, Structures, and Integrated Systems, (14 November 1997); https://doi.org/10.1117/12.293519
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Failure analysis

Carbon

Sensors

Polishing

Eye

Surface finishing

Surface roughness

RELATED CONTENT

Detection of damage location in ductile members
Proceedings of SPIE (August 24 2000)
Prediction of crack generation
Proceedings of SPIE (November 14 1996)
Visual stress sensor
Proceedings of SPIE (April 20 1995)

Back to Top