Design and method of fabricating phase-shift masks for extreme-ultraviolet lithography by partial etching into the EUV multilayer mirror

Sang-In Han; Eric Weisbrod; Qianghua Xie; Pawitter J. S. Mangat; Scott Daniel Hector; William J. Dauksher

doi:10.1117/12.484731

16 June 2003 Design and method of fabricating phase-shift masks for extreme-ultraviolet lithography by partial etching into the EUV multilayer mirror

Sang-In Han, Eric Weisbrod, Qianghua Xie, Pawitter J. S. Mangat, Scott Daniel Hector, William J. Dauksher

Author Affiliations +

Proceedings Volume 5037, Emerging Lithographic Technologies VII; (2003) https://doi.org/10.1117/12.484731
Event: Microlithography 2003, 2003, Santa Clara, California, United States

Abstract

Phase Shift Masks (PSM) for Extreme Ultraviolet Lithography (EUVL) have the potential for extending the lithographic capability of EUVL beyond the 45-nm node. Typical PSM structures, such as for attenuated PSMs (Att-PSMs), are similar to those of binary masks in the sense that patterned structures of one or more layers of absorber (attenuator) are constructed on the EUV multilayer mirror to provide the correct amount of attenuation and phase shift. However, another type of PSM implemented by etching into the Mo/Si multilayers, rather than by adding lithographic structures on top of the Mo/Si multilayers (additive approach) can provide the required phase shift for both attenuated and hard PSMs. One of anticipated technical challenges, i.e. terminating ethcing at a specific depth with good surface uniformity can be sovled by employing an etch stop layer (ESL) embedded at a target depth inside the multilayer. In designing PSMs using this subtractive fabrication technique, the position and thickness of the ESL should be optimized, so that optical function of the multilayer substrate with embedded ESL should be same or close to when it does not have any embedded layer. According to simulation, the print bias for PSMs by etching into the multilayer stack to create the phase shift is smallest and near ideal compared to other types of PSMs or binary masks fabricated by conventional methods. The increase of depth of focus by 25-75% for contacts using an attenuated PSM and by 50-100% for lines using an ideal har dPSM is another lithographic advantage as well. The design and method of fabricating PSMs by etchign intothe multilayers is described, which include the optimziation of the thinkness and dpeth of the embedded layer. Experimental results of the multilayer etch process demonstrate initial feasibility of the subtractive approach to fabricating EUV PSMs.

Citation Download Citation

Sang-In Han, Eric Weisbrod, Qianghua Xie, Pawitter J. S. Mangat, Scott Daniel Hector, and William J. Dauksher "Design and method of fabricating phase-shift masks for extreme-ultraviolet lithography by partial etching into the EUV multilayer mirror", Proc. SPIE 5037, Emerging Lithographic Technologies VII, (16 June 2003); https://doi.org/10.1117/12.484731

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available