RET application in 45-nm node and 32-nm node contact hole dry ArF lithography process development

Xiangqun Miao; Xumou Xu; Yongmei Chen; Chris Ordonio; Chris Bencher; Chris Ngai

doi:10.1117/12.707782

27 March 2007 RET application in 45-nm node and 32-nm node contact hole dry ArF lithography process development

Xiangqun Miao, Xumou Xu, Yongmei Chen, Chris Ordonio, Chris Bencher, Chris Ngai

Proceedings Volume 6520, Optical Microlithography XX; 65201F (2007) https://doi.org/10.1117/12.707782
Event: SPIE Advanced Lithography, 2007, San Jose, California, United States

Abstract

It is challenging to develop 45nm node contact hole using dry ArF lithography process with acceptable lithographic margin due to small process window and large mask error enhancement factor (MEEF). No single process using conventional lithography without resolution enhancement technique (RET) application will meet DOF requirement of 45nm node contact hole. We have developed dry ArF lithography processes for 45nm node contact hole on scanner ASML XT1400E by applying RETs including off-axis illumination, SAFIER (Shrink Assist Film for Enhanced Resolution) process, EFESE (focus scan), etc. The paper will discuss process window through pitches with optimized illumination, and where to separate pitches in case of double exposure with consideration of DOF and OPC model simulation. It will look into the effect of EFESE on DOF improvement, proximity, and MEEF at various pitches. The paper will also discuss OPC modeling strategy for 45nm node contact/via hole. It will analyze the effect of OPC grid size on OPC run time, file size, and edge placement error (EPE). To extend process further to 32nm node, we demonstrated the process capability for 32nm node hole using double patterning technique. We achieved 50nm final hole CD with pitch of 100nm. A hard mask (HM) technique was implemented in the process. The dense feature is designed into two complementary parts on two masks such that the density is reduced by half and minimum pitch is increased by at least a factor of 2^1/2 depending on design. The complete patters are formed with two litho-etch process steps. After the first mask litho process, the HM is etched. Then the second mask litho process is carried out and followed by a second HM etch and main etch.

Citation Download Citation

Xiangqun Miao, Xumou Xu, Yongmei Chen, Chris Ordonio, Chris Bencher, and Chris Ngai "RET application in 45-nm node and 32-nm node contact hole dry ArF lithography process development", Proc. SPIE 6520, Optical Microlithography XX, 65201F (27 March 2007); https://doi.org/10.1117/12.707782

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available