OPC model calibration considerations for data variance

Mohamed Bahnas; Mohamed Al-Imam

doi:10.1117/12.776896

7 March 2008 OPC model calibration considerations for data variance

Mohamed Bahnas, Mohamed Al-Imam

Proceedings Volume 6924, Optical Microlithography XXI; 69243U (2008) https://doi.org/10.1117/12.776896
Event: SPIE Advanced Lithography, 2008, San Jose, California, United States

Abstract

OPC models have been improving their accuracy over the years by modeling more error sources in the lithographic systems, but model calibration techniques are improving at a slower pace. One area of modeling calibration that has garnered little interest is the statistical variance of the calibration data set. OPC models are very susceptible to parameter divergence with statistical variance, but modest caution is given to the data variance once the calibration sequence has started. Not only should the calibration data be a good representation of the design intent, but measure redundancy is required to take into consideration the process and metrology variance. Considering it takes five to nine redundant measurements to generate a good statistical distribution for averaging and it takes tens of thousands of measurements to mimic the design intent, the data volume requirements become overwhelming. Typically, the data redundancy is reduced due to this data explosion, so some level of variance will creep into the model-tuning process. This is a feasibility study for treatment of data variance during model calibration. This approach was developed to improve the model fitness for primary out-of-specification features present in the calibration test pattern by performing small manipulations of the measured data combined with data weighting during the model calibration process. This data manipulation is executed in image-parameter groups (Imin, Imax, slope and curvature) to control model convergence. These critical-CD perturbations are typically fractions of nanometers, which is consistent with the residual variance of the statically valid data set. With this datamanipulation approach the critical features are pulled into specification without diverging other feature types. This paper will detail this model calibration technique and the use of imaging parameters and weights to converge the model for key feature types. It will also demonstrate its effectiveness on realistic applications.

Citation Download Citation

Mohamed Bahnas and Mohamed Al-Imam "OPC model calibration considerations for data variance", Proc. SPIE 6924, Optical Microlithography XXI, 69243U (7 March 2008); https://doi.org/10.1117/12.776896

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available