Many modern astronomical instruments rely on the optimal coupling of starlight into single-mode fibers (SMFs). For ground-based telescopes, this coupling is limited by atmospheric turbulence. We propose an integrated wavefront corrector based on silicon-on-insulator (SOI) photonics, which samples the aberrated wavefront via a microlens array (MLA). The MLA focuses the sampled wavefront onto an array of grating couplers that inject the beamlets into the single-mode waveguides of the corrector. The beams in each waveguide are then shifted in phase using thermo-optic phase shifters before combining the co-phased beams into one single-mode waveguide. In this work, we analyze the external factors that we anticipate will impact the performance of the corrector. Specifically, we study the effects of the telescope pupil function with obscuration, determine whether the corrector requires tip/tilt pre-correction, and analyze the impact of scintillation on the correction quality.
In ground-based astronomy, the ability to couple the light into single-mode fibers (SMFs) is limited by atmospheric turbulence, which prohibits the use of many astrophotonic instruments. We propose a silicon-on-insulator photonic chip capable of coherently coupling the out-of-phase beamlets from the subapertures of a telescope pupil into an SMF. The PIC consists of an array of grating couplers used to inject the light from free space into single-mode waveguides on a chip. Metalic heaters modulate the refractive index of a coiled section of the waveguides, facilitating the co-phasing of the propagating modes. The beamlets can then be coherently combined to efficiently deliver the light to an output SMF. In an adaptive optics system, the phase corrector would act as a deformable mirror commanded by a controller that takes phase measurements from a wavefront sensor. We present experimental results for the PIC tested on an AO testbed and compare the performance to simulations.
Photonic platforms and technologies can facilitate the miniaturization of astronomical instruments for high-resolution cross-correlation spectroscopy. Fibre Brag grating (FBG) arrays, inscribed into optical fibres using direct femtosecond laser writing, form a target-tailored instrument spectrum. Flexible modulation of spectral features is provided during instrument operation through strain tuning of the FBG arrays. This paper presents a prototype of an astrophotonic fibre instrument demonstrating cross-correlation spectroscopy for molecular gas absorption in the infrared spectrum. Experimental laboratory results of spectral modulation and cross-correlation analysis are shown to compare well with theoretical models for CO2 gas. Additionally, efforts toward the on-sky integration of the instrument on a 1-meter-class telescope are demonstrated for targeted near-infrared spectral features.
We report on simulations carried out for an integrated phase corrector that can efficiently couple the light distorted by atmospheric turbulence into a single-mode fiber (SMF). The photonic integrated circuit (PIC) consists of a square array of surface grating couplers used to deflect the off-plane wave vector of the free-space beamlets into the plane of a single-mode waveguide in the chip. Resistive elements acting as heaters are subsequently used to stretch a coiled section of the individual waveguides and, in doing so, shift the phase of the propagating modes. With the correct phase shifts applied to the channels — each corresponding to a subaperture on a telescope pupil — the channels can be coherently combined, and the collected light can be delivered to one output SMF. In an adaptive optics (AO) system, the phase corrector would act as a deformable mirror (DM) commanded by a controller that takes phase measurements from a wavefront sensor (WFS).
We assembled a testbed to study coupling of starlight through atmospheric turbulence via astronomical telescopes into astrophotonic devices. The setup allows for varying the turbulence strength and investigating the effects of different levels of adaptive optics correction on the efficiency of integrated optics. In addition to recording optical powers and wavefront errors, focal plane images are captured from which spots sizes and Strehl ratios are also measured. Novel astrophotonic components proposed as alternatives to conventional optical instruments can therefore be qualified in terms of coupling efficiency and throughput on the testbed before they are tested on the sky.
We present a method of assembling a fiber-optic pseudo-slit, inside a custom FC connector. 19 SMFs with 80 μm cladding diameters are arranged in a 1,511 μm pseudoslit, held in the center of a connector ferrule. The SMFs in the pseudo-slit are well positioned and well ordered, having an average core separation in the ‘long’ direction of 79.5 μm and an StDev in the ‘narrow’ direction of 2.68 μm. The nearfield output distribution of the pseudo-slit was measured under 615-730 nm light, finding an FWHM intensity distribution ratio between the two directions of 1 : 21.9. This method could be used with other types of optical connector, allowing pseudo-slits to be used conveniently with existing optical instruments.
We will review the development in the last decade of discrete beam combiners (DBC), phase sensors based on the propagation of light in photonic lattices. The latest results on the development of DBC for astronomical applications will be presented, along with a new application for the complete tomography of modes at the tip of a multi-mode fiber. The possible use of the DBC in monitoring and controlling modal instabilities in high power lasers will be discussed.
As compared to single-mode fibers (SMFs), photonic lanterns could ease the coupling of starlight to single-mode astrophotonic instruments. Here we investigate numerically the advantage of using lanterns as compared to SMFs for seeing-limited and low-order adaptive telescopes. We find the turbulence strength below which focal-ratio-matched photonic lanterns provide an average flux per output equal to that of a sole SMF. Lastly, we look into the advantage of having a low-order adaptive optics (AO) as a way of relaxing the demand on the lantern size and complexity.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.