Paper
7 June 1996 Simulations and experiments with the phase-shift focus monitor
Author Affiliations +
Abstract
Simulation has been used to better understand the process parameters which affect focus monitor performance. Full resist process simulations were done using PROLITH/2. Exposure dose, partial coherence and focus monitor linewidth were varied, assuming an aberration-free lens. The focus monitor result was in good agreement with simulations of two traditional focus test approaches. Simulations were also done with optics having significant third order spherical aberration. In this case, the results of the two traditional focus methods differed with each other, and the focus monitor gave another significantly different result. The focal plane of the aberrated lens depends on what pattern is being printed. Determining the crossing point of focus monitor calibration curves with different partial coherence may allow the lithographic measurement of spherical aberration. This paper also outlines recommendations for the practical use of the focus monitor, along with two examples. The first example illustrates a lens heating problem when using a stepper at a non-standard (sigma) value. The second example demonstrates a focus problem at the edge of the wafer caused by a non-flat chuck.
© (1996) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Timothy A. Brunner and Rebecca D. Mih "Simulations and experiments with the phase-shift focus monitor", Proc. SPIE 2726, Optical Microlithography IX, (7 June 1996); https://doi.org/10.1117/12.240909
Lens.org Logo
CITATIONS
Cited by 4 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Calibration

Monochromatic aberrations

Semiconducting wafers

Overlay metrology

Photoresist processing

Lithography

Reticles

Back to Top