Paper
12 November 1996 Fiber optic rate gyros
Joung C. Ha, Jeffrey L. Duryea, Carol A. Davis, Jeff Bush
Author Affiliations +
Abstract
Progress on the development of an ultra miniature fiber optic rate gyro is reported. A unique IFOG design implementing low cost components is presented where package volume is less than two cubic inches including electronics. This design is capable of meeting operational performance requirements over the temperature range of -57 to +71 C with electronic power limited to 3 watts. The IFOG circuit consists of an ELED source at 1.3 micrometers , a non-PM source/receiver multiplex circuit using a standard fused biconic tapered coupler, an annealed proton exchange integrated optic 'gyro chip', and a volume efficient 'racetrack' PM sensing coil configuration. Gyro electronics have been reduced to a single MCM board. A discussion of the design parameters, component requirements, and test data are presented.
© (1996) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Joung C. Ha, Jeffrey L. Duryea, Carol A. Davis, and Jeff Bush "Fiber optic rate gyros", Proc. SPIE 2837, Fiber Optic Gyros: 20th Anniversary Conference, (12 November 1996); https://doi.org/10.1117/12.258173
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Gyroscopes

Fiber optic gyroscopes

Electronics

Modulation

Receivers

Phase shift keying

Fiber optics

Back to Top