High-aspect-ratio single-crystal Si microelectromechanical systems

Jason W. Weigold; Stella W. Pang

doi:10.1117/12.324307

31 August 1998 High-aspect-ratio single-crystal Si microelectromechanical systems

Jason W. Weigold, Stella W. Pang

Proceedings Volume 3511, Micromachining and Microfabrication Process Technology IV; (1998) https://doi.org/10.1117/12.324307
Event: Micromachining and Microfabrication, 1998, Santa Clara, CA, United States

Abstract

A review of fabrication techniques and testing of single crystal Si resonant devices with high aspect ratio capacitive transduction mechanisms has been presented. Deep trenches have been etched in single crystal Si using a Cl₂ plasma generated by an electron cyclotron resonance (ECR) and an inductively coupled plasma (ICP) source. This etching has been extended to the fabrication of resonant devices thicker than 50 micrometer using a frontside-release process and these devices have been electrically tested. The thick devices allow larger capacitance between drive and sense plates, which in turn reduces required driving voltage and increases sensing current. In addition, an etching condition has been developed which can etch trenches as narrow as 0.1 micrometer to depths greater than 3 micrometer. This etch has been used to fabricate comb driven resonators with high aspect ratio gaps (greater than 30) between comb fingers. Finally, a fabrication method to integrate these single crystal Si mechanical devices with a conventional circuit process with only one additional masking step has been developed. Eleven micrometer thick clamped-clamped beam comb driven resonators have been fabricated and tested on the same chip with working CMOS transimpedance amplifiers. The resonator had a resonant frequency of 28.9 kHz and a maximum amplitude of vibration of 4.6 micrometer, while the amplifier had a 3-dB frequency of 150 kHz and a power dissipation of 1.25 (mu) W.

Citation Download Citation

Jason W. Weigold and Stella W. Pang "High-aspect-ratio single-crystal Si microelectromechanical systems", Proc. SPIE 3511, Micromachining and Microfabrication Process Technology IV, (31 August 1998); https://doi.org/10.1117/12.324307

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available