Paper
14 April 2010 Dynamic analysis of engine mounts at different orientations
Ooi Lu Ean, Zaidi Mohd Ripin
Author Affiliations +
Proceedings Volume 7522, Fourth International Conference on Experimental Mechanics; 752238 (2010) https://doi.org/10.1117/12.851828
Event: Fourth International Conference on Experimental Mechanics, 2009, Singapore, Singapore
Abstract
Rubber engine mounts are commonly used to provide v ibration attenuation. The loss factor and dynamic stiffness of engine mount provide fundamental information of the energy dissipation. This paper presented the effect of orientation angle on the damping characteristic of the engine mount. Firstly, the damping measurement is performed on the engine mount in the axial position. Dynamic driving point stiffness is measured. Secondly, the analysis is extended to measure and analyze the frequency dependent stiffness and loss factor at different orientation for the engine mount. The results showed that the stiffness of the engine mount decreases when the engine mount is shifted from vertical to horizontal position. The same observation was also made for the natural frequency of the system. The frequency dependency of the stiffness and loss factor are also shown in the analysis. The measured frequency dependent stiffness and loss factors are then used to reproduce the frequency response function.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ooi Lu Ean and Zaidi Mohd Ripin "Dynamic analysis of engine mounts at different orientations", Proc. SPIE 7522, Fourth International Conference on Experimental Mechanics, 752238 (14 April 2010); https://doi.org/10.1117/12.851828
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Transducers

3D modeling

Optical isolators

Signal attenuation

Systems modeling

3D metrology

Lutetium

RELATED CONTENT

Guided wave attenuation in composite materials
Proceedings of SPIE (April 05 2017)
Damping and isolation of the GHM mini-oscillators
Proceedings of SPIE (April 27 2000)
A new semi-active piezoelectric-based friction damper
Proceedings of SPIE (July 31 2003)
Integral control of collocated smart structures
Proceedings of SPIE (April 27 2007)

Back to Top