Paper
8 September 2010 Research of ZnS as a buffer layer for CIGS solar cells
Author Affiliations +
Abstract
Normally, CdS film is used as the buffer layer in the fabrication of copper indium gallium selenide solar cells. These solar cells can reach an efficiency of 10.3% when produced by a non-vacuum process. However, this is a very toxic process. In this study, we propose using a nontoxic zinc sulfide (ZnS) buffer layer which is deposited by chemical bath deposition. It took only 15 minutes to reach a ZnS thickness of 50nm and the transmittance of the finished device was higher than 80%. The back contact of the Mo layer sheet resistivity is 0.22 (Ω/square). The precursor solution for the cell fabrication was prepared from anhydrous hydrazine. The film was then deposited by spraying and finally heated rapidly to 520 without external selenization.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hsin-Wei Huang, Sheng-Hui Chen, and Cheng-Chung Lee "Research of ZnS as a buffer layer for CIGS solar cells", Proc. SPIE 7771, Thin Film Solar Technology II, 77710Q (8 September 2010); https://doi.org/10.1117/12.860410
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Zinc

Copper indium gallium selenide

Solar cells

Sputter deposition

Molybdenum

Thin films

Cadmium sulfide

RELATED CONTENT


Back to Top