Paper
1 October 2007 A microstitching interferometer for evaluating the surface profile of precisely figured x-ray K-B mirrors
Author Affiliations +
Abstract
Fabrication and evaluation of elliptical X-ray mirrors, such as Kirkpatrick-Baez (K-B) mirrors produced by the profile-coating technique, requires accurate surface figure measurements over a wide range of spatial frequencies. Microstitching interferometry has proven to fulfill this requirement for length scales from a few μm up to the full mirror length. At the Advanced Photon Source, a state-of-the-art microroughness microscope interferometer that incorporates advanced microstitching capability has been used to obtain measurements of profile-coated elliptical K-B mirrors. The stitched surface height data provide previously unattainable resolution and reproducibility, which has facilitated the fabrication of ultrasmooth (< 1 nm rms residual height) profile-coated mirrors, whose hard X-ray focusing performance is expected to approach the diffraction limit. This paper describes the system capabilities and limitations. Results of measurements obtained with it will be discussed and compared with those obtained with the Long Trace Profiler.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Lahsen Assoufid, Jun Qian, Cameron M. Kewish, Chian Liu, Ray Conley, Albert T. Macrander, Delvin Lindley, and Christopher Saxer "A microstitching interferometer for evaluating the surface profile of precisely figured x-ray K-B mirrors", Proc. SPIE 6704, Advances in Metrology for X-Ray and EUV Optics II, 670406 (1 October 2007); https://doi.org/10.1117/12.736384
Lens.org Logo
CITATIONS
Cited by 6 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Mirrors

Interferometers

Objectives

Microscopes

X-rays

Hard x-rays

Interferometry

Back to Top